> 5-Metrology-Equipment > 54-Laser-Measurement > 5401-Tire-Industry > 540101-Off-Line-ProfilometerOFLP-600-30 > OFLP-600-30
* Not actual product image
|
Off-Line Profilometer
The Starrett-Bytewise Profilometer was developed as an automated, non-contact measurement system to displace checking with hand tools. The Profilometer is used to verify the accuracy of newly-cut dies by checking the extrusion dimensions. Its accuracy and speed helps reduce the number of die trials needed to approve a new die for production. Once in production, the Profilometer is used to check each run for overall quality, and to monitor for die wear. The Starrett-Bytewise Profilometer can help you improve your extrusion quality, reduce raw materials cost, and reduce extruder down-time for die trials.
|
-
The Laser Sensor feature is optimized for accurate measurements on black rubber
-
The Thermal Protection feature turns sensors off at 45 degrees Celcius
-
The Servo-motor linear axis provides accurate and repeatable scan control
-
The Dual Axis Option permits averaging for up to three side-by-side scans
-
The Import Specifications feature imports XY break points from a data table
-
The Gauge Report lists the measured thickness values at each breakpoint along with the design specification and error amount
-
The Point Report lists the measured width values at each breakpoint along with the design specification and error amount
-
The Symmetry Report compares the right and left side point width, thickness, region area, and center of gravity
-
The Regional Report analyzes the area and center of gravity
-
The Conicity Report compares the area distribution of one side of the extruded component to the other side
-
The Graphical Overlay compares multiple runs
-
The INI file is used for configuration for testing and reporting schemes
-
The Optimized Calibration feature measures 16 thickness values and 4 angle values to assure accuracy across the entire range
-
The PC Controller allows easy replacement of a standard HP desktop PC from a local source
-
The IPC Option allows the customization of an Industrial PC per the customer's specifications
-
The Remote Support feature enables software updates and training via the Internet via a secure link
-
Width Range 600 mm or 1000 mm
-
Thickness Range 30 mm or 60 mm
-
Width Accuracy 0.0125 mm
-
Width Repeatability (1s) 0.0125 mm
-
Thickness Accuracy 0.0125 mm or 0.0250 mm
-
Thickness Repeatability (1s) 0.0125 mm or 0.0250 mm
-
Thickness Resolution 0.00875 mm or 0.0175 mm
-
Area Accuracy 0.025%
-
Area Repeatability (1s) 0.025%
-
Laser Spot Diameter, Top 0.1 mm or 0.3 mm
-
Laser Spot Diameter, Bottom 0.1 mm
-
Width Point Spacing 0.1 mm
-
Dual Axis Range 20 mm
-
Cycle Time 30 sec or 50 sec
-
Laser Frequency 16 kHz
-
Laser Resolution 0.008 mm
-
Current at 230V 10 A
-
Laser Classification, CDRH IIIb
-
Laser Classification, IEC 3b
-
Low Voltage Directive Yes
-
EMC Directive Yes
-
Machinery Directive Yes